Jade allows you to register and store multisig configurations on device, allowing for receive and change address verification when using Jade in this type of setup. You can register up to eight, 8-of-8 multisigs with Jade.
Wallet Registration
1.
Set up a multisig wallet using Jade as one of the keys on your desired wallet app. Next, prompt Jade to register the wallet in one of the following ways depending on your communication method:
- USB: On your wallet app, select to verify or display an address on Jade while your device is connected and active
- QR: Find the option to Export your wallet configuration using QRs on your wallet app, then scan the config using Scan QR on Jade while in an active session
Tip: Refer to your specific platform's documentation on how to set up multisig as the instructions will vary.
2.
Proceed through the involved signers on Jade and confirm the relevant information for each of them. Each field is selectable and can be viewed full screen if desired.
3.
After confirming the registration, Jade will be able to verify receive addresses for this wallet and will automatically validate change addresses during signing. This record can later be viewed by navigating to Options, Wallet, Registered Wallets while in an active session.