You can send bitcoin and Liquid assets from Blockstream Jade by connecting your device to your phone's Blockstream Green wallet. Note: Blockstream Jade is currently only supported by Blockstream Green for Android. iOS and desktop support will be added soon. 1. Make sure your Blockstream Jade wallet is charged. Connect it to your phone using a cable. Note: Depending on your phone, you may need to use your own cable depending on the USB connector available on your mobile device. Open Blockstream Green. 2. A dialogue window should pop up to ask if you want to use Blockstream Green to handle CP2104 USB to UART Bridge Controller. Tap OK. 3. Log into your wallet by entering your PIN code into your Blockstrean Jade device. If you have not created or recovered a wallet on Blockstream Jade yet, do that first. 4. On the home screen of your Blockstream Green application, tap Send. 5. Enter the receiving address and the amount you would like to send, then select the network fee you want to pay and tap Next. 6. Review the details of your transaction on Blockstream Green and drag the slider at the bottom of the screen to the right to initiate your transaction. 7. Blockstream Jade will display the transaction details for you to review. Carefully make sure the details are correct, then use the wheel above the screen to select the checkmark and press the physical rectangular button to confirm the transaction. 7. If you have two-factor authentication (2FA) set up for your wallet, Blockstream Green will now ask for your 2FA code. Enter the code using your selected 2FA method to complete the transaction.