Blockstream Jade has the ability to register your multisig descriptor information using QR Scan, which allows you to verify receive and change addresses on device when using Jade in generic multisig setups in a fully air-gapped manner. You can register up to eight, 8-of-8 multisigs with Jade. Register M-of-N Multisig 1. Set up a multisig wallet on your desired platform using a Blockstream Jade. 2. Next, navigate to your wallet app's functionality for exporting a multisig configuration via QR codes. 3. Select Scan on Jade and point the camera at the QR codes until the multisig config is fully captured. 4. Once scanned, Jade will ask if you would like to view and confirm the multisig descriptor information. Select the next arrow to begin viewing information about each of the signers involved with this wallet. Jade will then display the fingerprint, derivation path, xpub, and path for each signer. 5. After reviewing and confirming the information provided about each signer, select the checkmark to register this multisig. You may then use Jade to verify receive addresses using Scan, and Jade will also automatically verify your change addresses when it is being used as a signer for any transactions from this wallet.